Onderzoeksrapporten
Hier vindt u een overzicht van onderzoeksrapporten van Rijkswaterstaat, conform Woo artikel 3.3 lid 2 letter j.
Op deze plek publiceert Rijkswaterstaat de eigen openbare rapporten uit de periode 1822 tot heden en de openbare rapporten die in opdracht van Rijkswaterstaat opgesteld zijn. De databank omvat circa 64.000 rapporten in pdf-formaat.
Zoeken in de index
Aantal resultaten: 14
A short introduction is given of the Huet& Sayegh rheological model and the application on (the results for) three very different Dutch asphalt mixes. In contrast with the more known Burger's model the H&S model fits the master curve for an asphalt mix over a large range of frequencies ...
auteur(s): Ministry of Transport, Public Works and Water Management, Road and Hydraulic Engineering Division = Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 maart 2003
Background and mathematical treatment of the response for a varable dashpot (parabolic element) with special attention for the pseudo permanent deformation.
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW), Afdeling Laboratorium (IL); A.C. Pronk | Pronk, A.C.
1 maart 2003
Based on the closed integral solution procedures an attempt is carried out find a solutionfor the rectangular corner loading case of a thin plate testing on a Pasternak foundation. Although a complete proof could not be given, the presented solution can fullfil all the boudary requirements at ...
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW), Afdeling Infrastructuur, Laboratorium; A.C.Pronk | Pronk, A.C.
1 januari 2003
This report deals with the influences of system losses on the measured deflections in the dynamic four point bending test and forms the third part in the series of reports on the 'theory of the four point dynamic bending test'.
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 september 2002
The fatigue test used, is a four-point bending test. Prismatic specimens are fixed between four clamps. The two outer clamps do not allow vertical movement of the specimen. All four clamps shall allow free rotation and horizontal movement of the specimen. A vertical sinusoidal force is applied ...
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 juli 2002
This report contains the data of three point dynamic bending fatigue tests whcih were carried out for Workgroup 3 of the RILEM Technical Committee 152. The mix at issue is a French dense asphalt concrete which is made in the laboratory of LCPC (Nantes, France). The actual measurements are ...
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 januari 2000
Om recht te doen aan de respons van een materiaal zoals asfalt is een visco-elastische benadering minimaal nodig. De meest eenvoudige modellering is een lineair visco-elastisch model. Hierbij wordt weliswaar geen rekening gehouden met de zgn. instantane plastische (irreversibele) vervormingen, ...
auteur(s): Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 januari 2000
This working document describes the theory and application of a partia healing model in four point bending tests in controlled strain mode. The fatigue tests form a part of a larger investigation within the RILEM PEB TG3 group. Based on the results obtained for the 4PB tests the evolution of ...
auteur(s): A.C. Pronk, Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Dienst Weg- en Waterbouwkunde (RWS, DWW) | Pronk, A.C.
1 januari 2000
"SPECOMPACT" (Specifications for Compactions) is an international project, which was subsidied by the EC. Within the project the Road and Hydraulic Engineering Division of the Ministry of Transport, Public Works and Water Management (RWS, DWW) was responsible for the following items: the ...
auteur(s): A.C. Pronk : Ministry of Transport, Public Works and Water Management = Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Road and Hydraulic Engineering Division = Dienst Weg- en Waterbouwkunde (RWS, DWW) | Pronk, A.C.
1 januari 1999
Data of four point dynamic bending fatigue tests which were carried out for Workgroup 3 of the RILEM Technical Committee 152. The mix at issue is a French dense asphalt concrete which is made in the laboratory of LCPC (Nantes, France). The actual measurements are performed by Netherlands ...
auteur(s): Ministry of Transport , Public Works and Water Management = Ministerie van Verkeer en Waterstaat, Rijkswaterstaat, Road and Hydraulic Engineering Division = Dienst Weg- en Waterbouwkunde (RWS, DWW); A.C. Pronk | Pronk, A.C.
1 januari 1999
Direct naar
Zoeken op PUC-nummer
Veel van deze rapporten zijn gemigreerd vanuit het PUC-platform.
Deze rapporten zijn nu terug te vinden door te zoeken op het PUC-nummer in de link.
Bijvoorbeeld: als een link eindigt op PUC_726371_31/1/, dan is dit rapport te vinden door te zoeken op: PUC_726371_31